REDDNet Site Requirements

Depots

Our standard depot contains one dual-core AMD Athlon CPU, 4 GB of RAM, two 1 Gb network ports, and 4-8 TB of storage space. The standard depot draws approximately 300 W.

We are evaluating a new depot configuration with one 8-core Intel I7, 12 GB of RAM, two 1 Gb network ports, and 24 TB of storage space. This depot may optionally connect to the network via 10 Gb ethernet (via an add-on adapter). We will provide power requirements for this box at a later date.

IP Addresses

We require two externally-visible IP address for each depot. One address is for the depot itself, the other is for the management console.

Network Ports on your Switch

Each depot has two network interfaces, so if supported by your switch, we would like to use both interfaces in 802.3ad bonding mode for increased performance. This requires two switch ports and two ethernet cables per depot. If not supported, then each depot only requires one port/cable.

In addition, each depot has an ethernet port for the management console. The management consoles can connect directly to your primary network switch, or they can run off a smaller dumb switch to minimize the number of primary switch ports in use.

Required Network Ports

These ports should be opened on your perimeter firewall (or firewalls if you have both organizational and departmental firewalls).

• Management interfaces:

Port	Service	Notes
tcp/22	ssh	from all depots to 129.59.197.90
tcp/80	www	from all depots to 129.59.0.0/16
tcp/443	https	from all depots to 129.59.0.0/16
tcp/5900 and 5901	vnc	from all depots to 129.59.0.0/16

• Depot network interface:

Port	Service	Notes
tcp/22	ssh	from all depots to 129.59.197.60 and 129.59.197.90
tcp/5666	nagios	from all depots to 129.59.197.60 and 129.59.197.90
tcp/6714	ibp	from all depots to world
tcp/4823	bwctl	from 1st depot to world
tcp/861	owamp	from 2nd to world
udp/123	ntp	allow outbound from local depots
udp/161	snmpv3	from all to 129.59.197.60 and 129.59.197.90